Every sheet metal job has its own geometry, and a catalogue machine rarely fits it. This non standard automatic spot welding machine is configured around the part you weld: head count, stroke, fixture, table length and control logic are all built to your drawing. Send a sample or a 3D model, and our engineers return a fixture layout, a weld spot map and a cycle time estimate before steel is cut.

Once the fixture is locked, the machine repeats the same weld without operator judgement. Servo axes index the work piece between spots, the controller stores a separate schedule per program, and water cooled electrodes hold their shape through long shifts. Splash stays contained, the heat affected zone stays narrow, and coated panels need no re-finishing.

(All values are set by the work piece. Confirm your range before ordering.)

• Custom fixture and weld spot layout from your 3D model
• Multi head welding, up to 12 electrodes on one gantry
• Servo indexing between spots, repeatability within 0.05 mm
• PLC with HMI and 100 program memory
• Water cooled electrodes hold geometry through long shifts
• Safety light curtain and two hand start

Built for long runs of sheet metal assemblies where a hand welder cannot hold both position and pace. Typical parts include electrical cabinets, elevator door panels, storage racks, chassis brackets, kitchen equipment shells and hardware blanks that need a fixed spot pattern.

• Custom welding automation since 2006, ISO 9001 certified
• Pre-shipment acceptance test run with your sample parts
• Fixture design and build included
• Online technical support 24 hours, 7 days a week